off
When You Book Multiple Courses.
Qualify By Booking Multiple Places Or Courses. Book With Friends Or Your Team.
A spill kit is a collection of pollution control equipment kept in one place, ready to contain and soak up a leak of oil, fuel or chemicals before it reaches a drain, watercourse or open ground. A typical kit holds absorbent (sorbent) pads, booms, pillows and loose granules, along with drain covers, protective equipment and a container for the used materials. The right contents depend on what you store and use on site, so there is no single kit that suits every job.
Many spills on site involve substances that are hazardous to health as well as to the environment. Our COSHH Awareness course page explains how we help teams handle hazardous substances safely and know what to do when something goes wrong.
What is in a spill kit?
Pollution prevention guidance GPP 22: Dealing with spills, published by the environmental regulators for Wales, Scotland and Northern Ireland, describes the equipment a spill kit can include. Most kits are built from the items below:
| Item | What it does |
|---|---|
| Sorbent pads, sheets or rolls | Soak up liquid on hard surfaces |
| Sorbent booms | Contain a spill to stop it spreading, or divert the flow away from a drain |
| Sorbent pillows | Soak up liquid where it collects, for example under a leak |
| Loose granules | Soak up small spills on hard ground |
| Drain mats or drain covers | Seal a drain gully or manhole cover so liquid cannot enter the drainage system |
| Leak sealing putty | Temporarily block a hole in a leaking container or pipe |
| Personal protective equipment | Protect the person dealing with the spill, matched to the substances on site |
| A container for used sorbents | Hold contaminated materials until they can be disposed of safely |
GPP 22 also notes that, if no sorbent products are available, dry sand or earth can soak up an oil spill, and sand bags can be used to block drains or channel a spill. Government guidance on storing fuel oil also lists sand and earth as options for soaking up spilled oil.
Types of spill kit
Sorbents are not all the same. GPP 22 explains that there are different types, for example oil selective and chemically resistant sorbents, and that you should check with your supplier which are suitable for the materials you store. HSE guidance on emergency response and spill control also refers to process specific spill kits for acids, alkalis, solvents and toxic substances. In practice you will usually come across:
- Oil only kits. Use oil selective sorbents that pick up fuels and oils. GPP 22 notes that only oil selective sorbent booms will work for collecting oil on water.
- Chemical kits. Use chemically resistant sorbents for acids, alkalis and other aggressive chemicals.
- General purpose kits. Sold by suppliers for everyday mixed liquids. Check the supplier information for what the kit can and cannot handle.
- Vehicle kits. GPP 22 says all vehicles transporting goods should carry a spill kit and PPE appropriate to the load, and some vehicles may need a dual purpose kit for both the load and the fuel tank.
Some suppliers colour code their kits by type, but the government and regulator guidance referred to here does not set a colour scheme for spill kits. Always read the label on the kit and the safety data sheet for the substance, rather than relying on colour alone. For help reading chemical labels, see our guide to the COSHH hazard symbols.
Where should spill kits be kept?
Government guidance on pollution prevention for businesses says you should have a spill kit suitable for the products on your site available near storage, loading areas and transfer routes. NetRegs adds that kits should be kept close to where they might be needed, particularly in delivery areas, and that staff should know where they are. GPP 22 also recommends a second kit in an alternative location, in case it is not safe to reach the first one during an incident.
Kits are only useful if they are complete. Restock a kit after every use and include its location in your site plan. If you store oil on site, the oil storage regulations for businesses in England and Wales also require secondary containment, such as a bund, for oil containers of 201 litres or more at a business.
How to use a spill kit
GPP 22 sets out a pollution control hierarchy: stop the spill at its source, then as close to the source as possible, then stop it reaching drains or unsurfaced ground. On site, that means:
- Assess before you act. Check the label or safety data sheet for the substance. Health and safety always takes priority, so do not put yourself in danger.
- Put on the right PPE from the kit before you approach the spill.
- Stop the source if it is safe. Close a valve, turn a leaking drum so the hole is at the top, or plug the hole with leak sealing putty.
- Protect the drains. Cover nearby drain gullies and manholes with drain mats. NetRegs recommends colour coding drain covers blue for surface water and red for foul water, so you know where a spill would end up.
- Contain the spill with sorbent booms to stop it spreading.
- Soak it up with pads, pillows or granules.
- Contain the waste. Used sorbents soaked in oil or chemicals are classed as hazardous waste and must be disposed of under the waste duty of care.
- Report it. Tell your supervisor, and restock the kit.
Never hose a spill down or use detergents to clear it, as government guidance warns this can make the pollution worse. If a spill has entered, or could enter, a watercourse or soak into the ground, call the Environment Agency incident hotline on 0800 80 70 60, which runs 24 hours a day.
Who should be trained to use a spill kit?
Anyone who might have to deal with a spill should know how to use the kit. The pollution prevention guidance says deliveries should be supervised and that the people involved should know what to do if there is a spill and how to use the spill kit safely and effectively. GPP 22 adds that staff should be trained in how to use the equipment safely and what PPE they need, and that drivers should be trained to use vehicle spill kits.
Where the spill involves a substance hazardous to health, COSHH also applies. Regulation 13 of COSHH requires employers to prepare procedures for accidents, incidents and emergencies involving those substances, and regulation 12 requires suitable information, instruction and training for employees who may be exposed. In practice, that usually means:
- Storekeepers and anyone receiving fuel or chemical deliveries
- Plant operators and anyone refuelling machinery or generators
- Supervisors who will lead the response and decide when to report an incident
- Delivery drivers carrying fuel, oil or chemicals
Our COSHH Awareness course covers identifying hazardous substances in the workplace, safe handling techniques, personal protective equipment, effective COSHH assessments and the basic COSHH legal requirements. For the environmental side, our CITB Site Environmental Awareness Training Scheme (SEATS) course is a one day course that covers the prevention of pollution and water management, site waste management and being a responsible contractor. Dust is another site hazard that needs controls: see our guide to silica dust exposure.
Target Zero has more than 10,000 verified reviews on Reviews.io and a 4.9 rating on Trustpilot.
FAQs
What should be in a spill kit?
Sorbent pads, booms, pillows and granules, drain covers, leak sealing putty, PPE suited to the substances on site and a container for used materials. Match the contents to what you store and use.
What are the different types of spill kit?
The main types are oil only kits with oil selective sorbents, chemical kits with chemically resistant sorbents for acids and alkalis, general purpose kits for everyday liquids, and vehicle kits.
Where should a spill kit be kept on site?
Near storage, loading areas and transfer routes, close to where a spill is most likely, with a second kit in another location in case the first cannot be reached safely.
How do you dispose of a used spill kit?
Sorbents soaked in oil or chemicals are classed as hazardous waste. Keep them in a suitable container and dispose of them through the correct waste route under the duty of care.
Do you need training to use a spill kit?
Government guidance says the people involved in deliveries should know how to use the spill kit safely and effectively, and regulator guidance says staff should be trained in its safe use and the PPE they need.
Who do you call if a spill reaches a drain or river?
In England, call the Environment Agency incident hotline on 0800 80 70 60, which is available 24 hours a day.
A spill kit only works if the people on site know how to use it. Give your team the knowledge to handle hazardous substances and respond to spills: see dates and details on our COSHH Awareness course page, or call 0333 444 0018 to talk to our team.
prices
ever
Complete All NVQs, From Anywhere
Flexible Remote Learning with an Assessor – Start Now From 0% Deposit*
*Eligibility Criteria Apply

































